Home
---------------------------------
About Us
---------------------------------
 Products & Service
---------------------------------
Specification & Safety
---------------------------------
Project Gallery
---------------------------------
Contact Us
---------------------------------
Site Map
---------------------------------
 
 

Specification & Safety

Playground Equipment Material specification

Post

Upright post shall be 114mm or 90mm outside diameter and 3mm thick round post. The shall be cleared into six bath system prior to painting. All post shall have a baked-on electro statically applied polyester dry powder coating.

SQUARE DECK
Fabricated from regular carbon steel plate thickness 3mm comes with a series pattern punched hole 20mm diameter equivalent space. This deck covers of 1m2 top surface areas. Bottom of this plate has a welded steel frame and cross reinforced frame for their structural integrity. Product finished must be galvanized to comply with MSS 966 : Part 1 before sent to powder coated finished.


BOLTS, NUTS, FASTENING HARDWARE

All connecting hardware such as bolts, nuts, set screws, washers, etc is made from fully stainless steel. A protective cap will should be used for bolts head and nuts to avoid loosening and vandalism.

METAL COMPONENTS
All steel pipe are protected by anti-corrosion resistant prior to galvanizing and powder coated finished. Steel section shall conform to the dimensions and quality equirements of ASTM A500 and shall have a minimum tensile strength of 410 MPa.


PLASTIC COMPONENTS

Selections of plastic components are based on their suitability for outdoor use and are strengthen for mechanical impact. All plastic components shall retain their properties in the temperature range from 40oc to 70oc. Rotational moulded components such as slide have a double layered wall with thickness from 6mm to 10mm. Plastic panel is made from manlapene, the ultimate technology in play equipment plastic. The material shall comply with ASTM-D-638 tensile strength. They are moulded in various colors with (UV) within the frame of the strongest environmental demands.

ROOFING
The roof has a minimum 5mm wall thickness made from manlapene, the ultimate technology in play equipment plastic. The material shall comply with ASTM-D-638 tensile strength. They are moulded in various colors with (UV) within the frame of the strongest environmental demands.


SWING

The crossbeam is fabricated from 2 1/2inch x 1 1/2inch square hollow section.The length of the beam shall be based on the number of seats per swing. The swing legs are fabricated from 64mm outer diameter galvanized steel pipes and are powder coated finished. The legs are anchored with concrete foundation with a minimum depth of 500mm. The swing wire rope top joint have ball bearings inserted to ensure the smooth running of the swing. The flat swing seat is well padded with the outer layer of moulded-in-rubber called EPDM (ethylene proplene diene monomer) and hanging into a triangle shape cling made from stainless steel.

SEE-SAW
See saw coil spring shall be made of steel rods 160mm outer diameter and 430 height. The seat shall be made from manlepene. All components shall be free of sharp edges.


SPRING ITEMS

Spring items come with coil spring. All coil spring shall be 140mm outer diameter and 380 height. Springs are bonded to a steel plate for easy movement in any horizontal direction. All saddles shall be made of high density polyethylene (HDPE) and shall be free of sharp edges.

 

Copyright © 2013 Ebits Enterprise (M) Sdn Bhd
All rights reserved. || Powered by:
Integrated Southern Publications Sdn Bhd.